RF Safety Training for Engineering Teams

A high-power amplifier is not inherently dangerous because of its nameplate rating. Risk arises when radiated, coupled, or leaking electromagnetic energy reaches people under actual operating conditions. A test setup may be safe at the instrument panel yet create an...

When an RF Engineering Consultant Adds Value

A prototype can appear functional on the bench and still fail where the product must perform: at temperature, under vibration, near metal, inside an enclosure, at the edge of a required band, or after a manufacturing substitution. An RF engineering consultant is most...

Microwave Heating Design for Uniform Results

A microwave system can deposit useful energy in seconds while leaving a colder region millimeters away. That contrast is the central engineering challenge in microwave heating. A successful design is not defined by magnetron or solid-state source power alone. It is...

Electromagnetic Engineering That Meets Specifications

A receiver loses sensitivity only after enclosure hardware is installed. A microwave dryer heats the product surface while its core remains wet. An antenna prototype meets simulation targets but fails when mounted in its intended platform. These are not isolated...